Audiobus: Use your music apps together.
What is Audiobus? — Audiobus is an award-winning music app for iPhone and iPad which lets you use your other music apps together. Chain effects on your favourite synth, run the output of apps or Audio Units into an app like GarageBand or Loopy, or select a different audio interface output for each app. Route MIDI between apps — drive a synth from a MIDI sequencer, or add an arpeggiator to your MIDI keyboard — or sync with your external MIDI gear. And control your entire setup from a MIDI controller.
Download on the App StoreAudiobus is the app that makes the rest of your setup better.
Midi Latch/Extend/Hold
Posted this on Intua forum a little while ago, but there’s a sixer on the line and no one has responded:
What up y’all? Was hoping for a little help on a debate question and I’m not near my iPad to test. Will midi latch (midi tools) extend a sample to the length you paint the midi in the piano roll? I don’t mean extend indefinitely, just a bit. Lets say you have a vinyl piano chord that is 3/4 of a bar long and you want it to span the full bar. I know you can use sample loop in BM3 or add delay to make the sample longer, but I was curious if midi latch will do this. I’ve seen it done in ableton where you can stretch a specific part of the sample like the tail (not time stretching the whole thing) by literally highlighting and pulling/stretching a portion of the sample (like taffy for the visual learners). Thanks in advance and again sorry if this is a silly question.
Comments
I've just replied on the Intua forum (approx 1 hour after you posted it)
I have to sleep occasionally you know
Copy of my reply (for posterity/anyone else reading with the same question):
Short answer: Yes
Latched pads containing audio samples* will continue to play until one of three things happens...
* Latched pads with plugins/synths loaded behave similarly, but point #2 above doesn't apply, and it depends instead on the envelopes and settings in the plugin to determine how long a note sustains if you latch it.
My bad TK, there’s beer on the line! I bet someone and utilized full poker face mode because I was only 70% sure. Thank you
Note - if the sample is exactly 3/4 bar, it will stop at 3/4 bar.
Latch mode doesn't have any magical powers.
You'll have to either timetretch it, tune it down, enable a loop, or increase the project tempo to make it fill the entire bar